Shure DCS 6000 User Manual page 60

DIS Digital Conference System
This message indicates the priority of a microphone.
<seat_number>: The microphone that was adjusted
<priority>: The priority. Possible values: 0 to 5, where 0 is the lowest priority and 5 is the highest
priority
10.2.2.11 Seat State
Information about a seat.
seat_state <seat number> <seat state> <name><CR>
This information is sent from the CU to an external control application in the following situations:
When a delegate logs in
When a delegate logs out
•
When the seat name is modified
•
When the external control application requests microphone status (mic_status).
•
When a microphone unit becomes lost or found
•
•
<seat number> The seat number identification of a microphone unit. An integer ranging from 1 to
65535.
<seat state> The current state of the seat. This can be "active" or "passive"
<name> The seat name or delegate name. If a delegate name is available for the seat number then the
delegate name is provided. Otherwise the seat name is provided.
Example:
This command informs about seat number 12, which is active and has the name 'John Jones' attached.
seat_number 12 active John Jones<CR>
10.2.2.12 Microphone status complete
Informs, that complete system status has been sent.
mic_status_done<CR>
10.2.2.13 Command error
The CU has received an unknown command.
command_error <error text><CR>
<error text> is a text explaining the fault case.
Example:
command_error unknown command<CR>
command_error syntax error<CR>
User Manual CU 6110 rev A.docx
User Manual
60