Commands From Cu 6110 To External Control - Shure DCS 6000 User Manual

DIS Digital Conference System
The CU responds to this command by returning a list of commands for the Audio settings:
10.3.2

Commands from CU 6110 to External Control

10.3.2.1 Loudspeaker volume
Volume of loudspeakers for all Conference units.
loudspeaker_volume <volume><CR>
<volume> The volume of the loudspeakers ranging from -41 to 0. The value -41 indicates Off, whereas values from -
40 to 0 indicates attenuation in dB.
10.3.2.2 Line input 1 level
Level of line input 1 signal.
line_input_level_1 <level><CR>
<level> The level of line input 1 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
10.3.2.3 Line input 2 level
Level of line input 2 signal.
line_input_level_2 <level><CR>
<level> The level of line input 2 ranges from -41 to 0. The value -41 indicates Off, whereas values from -40 to 0
indicates attenuation in dB.
10.3.2.4 Line input 1 gain
Adjust input gain of line in 1 input.
line_input_gain_1 <gain><CR>
<gain>: 0 or 10
Gain can be set to 0 dB or 10 dB. 0 dB will not add any gain to the line input whereas 10 dB will add 10 dB gain to the
line input.
Only available on CU61xx
10.3.2.5 Line input 2 gain
Adjust input gain of line in 2 input.
line_input_gain_2 <gain><CR>
<gain>: 0 or 10
line_output_volume (for all outputs)
loudspeaker_volume
audio_path (for all paths)
line_input_level (for all inputs)
line_input_gain (for all inputs)
mic_speaker_attenuation (for all microphones)
mic_attenuation (for all microphones)
audio_status_done
User Manual CU 6110 rev A.docx
User Manual
63