Loading Paper In The Multi Purpose Drawer - Sharp DM-3551 Operation Manual

Loading paper in the multi purpose drawer

The method of loading paper into the multipurpose drawer is the same as for paper tray 1 described on page 1-16.
For specifications of paper, see page 1-17. When loading envelopes, postcards or transparency film, follow the
descriptions below.
Two maximum height lines are indicated: one for plain paper and one for special paper.
Maximum height line for plain paper
Do not exceed this line when loading plain paper.
Maximum height line for special paper (red line)
Do not exceed this line when loading special paper.
How to change the paper size
To change the paper size or paper type when paper is loaded into a tray, refer to page 1-19 for details.
Setting envelopes or postcards
When setting envelopes or postcards in the multi purpose drawer, set them in the orientation shown below.
Loading postcards
Load postcards print side up to the rear left of the tray
as shown.
Printing onto envelopes or postcards
Attempting to print onto both sides of envelopes or postcards may result in misfeeds or poor prints.
Do not use pre-printed envelopes.
To avoid wrinkling, misfeeds or poor printing, make sure the postcard stock is not curled.
Loading envelopes
Envelopes can only be printed on the address side. Be
sure to place envelopes with the address side up and
the top of the envelope to the rear.
LOADING PAPER
1-21
1