Pamphlet Copy - Sharp DM-3551 Operation Manual

Pamphlet copy

The pamphlet copy function is used to arrange copies in proper order for eventual center-stapling and folding into a
booklet. Two original pages are copied onto each side of copy paper. Four pages are, therefore, copied onto one sheet.
[Example] Copying eight originals in the pamphlet copy mode
Originals (one-sided)
Left binding
For left to
right turning
1
2
3
4
5
6
7
8
Originals (two-sided)
2
4
6
8
Right binding
1
For right to
3
5 left turning
7
1
Touch the [PAMPHLET COPY] key on the
SPECIAL MODES screen.
PAMPHLET COPY
2
Designate the type of originals to be copied: 1-
sided or 2-sided.
ORIGINAL
1-SIDED 2-SIDED
3 Select the binding position (left binding or right
binding) and touch the [OK] key.
CANCEL OK
LEFT RIGHT
BINDING BINDING
4
Touch the [OK] key on the special modes screen.
5
Copy from the first page to the last page from
either the document feeder or the document
glass.
Finished copies are
folded in two.
First page
First page
The pamphlet copy setting
screen will appear.
G
Scan the originals from the first page to the last page.
The order of copying will be automatically adjusted by
the machine.
G
Either left binding (right to left turning) or right binding
(left to right turning) can be selected.
G
Four originals will be copied onto one sheet. Blank
pages may be automatically produced at the end
depending on the number of the originals.
G
When using this function, a duplex module must be
installed.
G
If a saddle stitch finisher is installed, copies can be
stapled in two positions along the center of copies
and folded at the center.
6
Ensure that the desired paper size has been
automatically selected based on the original size.
AUTO
11 17
X
PAPER SELECT
%
100
COPY RATIO
7
Make all other desired settings such as exposure
or the number of copies, and press the [START]
key.
8
[When using the automatic document feeder:]
Copying will start after all originals have been scanned.
(The next step is not needed.)
[When using the document glass:]
Replace the original with the next original and press
the [START] key. Repeat this operation until all originals
have been scanned.
9
Touch the [READ-END] key. (only if the document
glass is used)
PLACE NEXT ORIGINAL. PRESS [START].
WHEN FINISHED, PRESS [READ-END].
READ-END
When the pamphlet copy function is set, the two-
sided copying mode will be automatically selected
and cannot be changed.
To cancel the pamphlet copy function, touch the [CANCEL]
key on the pamphlet copy setting screen.
SPECIAL FUNCTIONS
To select another size
paper, select the desired
size and touch the [AUTO
IMAGE] key. The
appropriate copy ratio will
be selected automatically
based on the original size
and the paper size. (See
steps 2 and 3 on page 16.)
23