Loading Paper; Loading Paper In Paper Tray 1; Changing The Paper Size In Paper Tray 1 - Sharp DM-3551 Operation Manual

LOADING PAPER

The message "ADD PAPER" or "OPEN TRAY
Follow the procedure below to load paper.
NOTES
Do not use curled or folded paper. Doing so may cause a misfeed.
For best results use paper supplied by SHARP . (See page 1-18.)
When you change the paper type and size in paper tray 1, set the paper type and size referring to "Setting the
paper size and type" (page 1-19).
Do not place heavy objects or press hard on any tray which is pulled out.

Loading paper in paper tray 1

1
Pull out paper tray 1.
2
Load paper into the tray.

Changing the paper size in paper tray 1

For paper tray 1, 8-1/2" x 11", A4 or B5 size paper can be set. Use the following procedure to change the size as
needed.
1
Pull out paper tray 1.
If paper remains in the tray, remove it.
2
Adjust the guide plates A and B in the tray
to the length and width of the paper.
3
Load paper into the tray.
1-16
AND ADD PAPER" will appear when paper runs out during operation.
Gently pull the tray out
until it stops.
Do not load paper above
the maximum height line
(approximately 500
sheets of 20 lbs. (80 g/m 2 )
paper).
The guide plates A and B
are slidable. Adjust them
to the paper size to be
loaded while squeezing
their lock levers.
3
Gently push tray 1 into the machine.
Push the tray firmly all the way into the machine.
4
Set the paper type.
If you change the paper type, be sure to set the
paper type referring to "Setting the paper size and
type" (page 1-19).
5
Loading paper in paper tray 1 is now
complete.
4
Gently push tray 1 into the machine.
Push the tray firmly all the way into the machine.
5
Set the paper size.
Be sure to set the paper size and paper type
referring to "Setting the paper size and type" (page
1-19).
If this is not done, paper misfeeds will occur.
6
Changing paper size in paper tray 1 is now
complete.