Sharp DM-3551 Operation Manual page 93

Using the auto document feeder
7
Press the START key.
(This is called "Quick on-line"-refer to the following page.)
If there is a previously stored job or a job is in progress, or
if the line is being used, all pages of the document are
scanned into memory and stored as a transmission job.
(This is called memory transmission: the destination is
automatically called and the document transmitted after
previously stored jobs are completed.)
If scanning is completed normally, the machine makes a
beep sound to inform you that the transmission job is stored
and JOB STORED appears in the message display.
NOTES
• Canceling transmission
To cancel transmission while SCANNING ORIGINAL... appears in the display or before the READ-END key is pressed, press
the C key or the CA key. To cancel a transmission job that is already stored, press the JOB STATUS key and cancel the job
as explained on page 2-6.
• If the machine makes two beeps during or at the end of transmission and an error message appears in the message display,
refer to page 7-3 to fix the problem.
• If the power is turned off or a power failure occurs while a document is being scanned in the auto document feeder, the
machine will stop and a document jam will occur. After power is restored, remove the document as explained on page 29 of
"Operation manual (for copier)".
Scanning begins.
If a job is not in progress
and the telephone line is
not being used, the
destination is called after
the first page is scanned.
Transmission takes place
as the document pages
are being scanned.
Using the document glass
7
Press the START key.
8
If you have another page to scan, change pages
and then press the START key.
Repeat this sequence until all pages have been scanned.
You can change the resolution and exposure settings
as needed for each page (refer to pages 1-9 and 1-10).
If no action is taken for one minute, scanning
automatically ends and the transmission job is stored.
9
After the final page is scanned, touch the READ-
END key.
L. (Pg.No. 3)
ESS [READ-END].
READ-END
Open the document glass cover and remove the
document.
SENDING A FAX
The original is scanned
and the READ-END key
appears.
The machine makes a beep
sound to inform you that the
transmission job is stored
and JOB STORED appears
in the message display.
(The destination is
automatically called and the
document transmitted after
previously stored jobs are
completed.)
2-3
2