Automatic Document Feeder - Sharp DM-3551 Operation Manual

SCANNING SETTINGS (ORIGINAL SIZE,
RESOLUTION, EXPOSURE, AND FILE FORMAT)
When sending an image, you can adjust the original size, resolution, exposure, and file format settings as needed.
MANUALLY SETTING THE SCANNING SIZE
If you load an original that is not a standard size (such as an AB size), or if you wish to change the scanning size, touch
the ORIGINAL key and set the original size manually. Perform the following steps after loading the document in the
automatic document feeder or on the document glass.
NOTE
Standard sizes that can be detected are as follows:
5-1/2"x8-1/2", 8-1/2"x11", 8-1/2"x11"R, 8-1/2"x14", 11"x17". If a non-standard size original is loaded (including special sizes),
the closest standard size may be displayed, or the original size may not appear at all.
1
Touch the ORIGINAL key.
RESOLUTION
PROGRAMMED
FILE FORMAT
AUTO 8 X11 1 /
2
ORIGINAL
2
Touch the MANUAL key.
ORIGINAL SIZE
UTO MANUAL
2-SIDED 2-SIDED
ST
BOOKLET TABLET
ROTATE THE IMAGE 90 DEGREE
NOTE
If you wish to rotate the original 90° when creating an image
file, click the "Load the original so that the image is oriented
horizontally" checkbox (a checkmark should appear in the
box).
3
Touch the desired original size key.
ORIGINAL SIZE
OK
AUTO MANUAL
OK
5 X8 1 / 1 / 5 X8 R 1 / 1 /
2 2 2 2
1 / 1 /
8 X11 8 X11R AB
2 2
8 X14 1 / 11X17 INCH
2
NOTE
You can return to automatic detection by pressing the CA key.
12
The sizes that can be
selected are displayed.
AUTO is no longer
highlighted. MANUAL and
the original size key you
touched are highlighted.
If you wish to select an AB size, touch the
AB INCH key and then touch the desired
original size key.
ORIGINAL SIZE
OK
AUTO MANUAL
OK
A5 B5R B4
A5R A4 A3
AB
B5 A4R INCH
4
Touch the outer OK key.
OK
L A4
OK
5
The selected size appears in the top half of the
ORIGINAL key.
RESOLUTION
PROGRAMMED
FILE FORMAT
A4
ORIGINAL
AB is highlighted and AB
size keys are displayed. To
return to the inch palette,
touch the AB INCH key
once again.
You will return to the initial
screen. (Pressing the inner
OK key in the step above
returns you to step 2.)