Troubleshooting (Concerning The Saddle Stitch Finisher) - Sharp DM-3551 Operation Manual

SADDLE STITCH FINISHER

Troubleshooting (concerning the saddle stitch finisher)

Check the list below before calling for service.
Problem
Stapling position Stapling position not set properly?
is not correct
(including saddle
stitch).
The saddle stitch Are any saddle stitch finisher covers
finisher does not open?
operate. Message indicating need to remove
paper from the stapler compiler
displayed?
Stapling cannot Message requesting check for the staple
be performed unit displayed?
(including saddle Message requesting adding staples
stitch). displayed?
Different size paper included?
Paper heavily curled?
Stapled sets are
not stacked
correctly or some
sheets in a set
are not stapled.
Cannot be Message requesting check for punch
punched.* module displayed?
* When a hole punch module is installed
5-26
Check Solution or cause
Check the stapling position setting. (See pages
5-27 and 5-28.)
Close all covers. (See page 5-17.)
Remove all remaining paper from the stapler
compiler referring to step 4 on page 5-22.
Remove jammed staples. (See page 5-22.)
Replace the staple cartridge. (See page 5-21.)
Check that a staple cartridge has been installed.
(See page 5-22.)
Stapling cannot be performed onto different size
paper.
Paper may be curled heavily depending on the
paper type and quality. Remove paper from the
paper tray or the bypass tray, turn it upside down,
and load it again.
Dispose of punch scraps. (See page 5-23.)