Setting Originals - Sharp DM-3551 Operation Manual

SETTING ORIGINALS

I I I I I When using the automatic document
feeder
1
Ensure that there is no original on the document
glass.
2
Adjust the original guides to the size of the
originals.
3
Place the originals face down in the document
feeder tray.
Set the originals all the way
into the feed slot. Do not
exceed the maximum
height line marked on the
original guide.
I I I I I When using the document glass
Open the document cover, place an original face
down on the document glass, and then gently
close the document cover.
Original size detector
NOTE
Do not place any objects under the original size
detector, because they may damage it or the original
size may not be detected properly.
Original scale
mark
5 1 8 1
/ x /
2 2
or A5
8 1
/ x 14
2
or B4 or B4
8 1
/ x 11 or A4 11x17 or A3
2
G
Set an original by aligning its corner with the tip of the
scale ( ) mark at the left rear corner of the glass as
shown in the illustrations.
Original scale
mark
8 1 11R or A4R
/ x
2
7