Installing The Scsi Ribbon And Power Cables - Epson Powerspan 2 User Manual

To install a fifth or sixth SCSI drive in the upper external bays,
follow the instructions on page 7-3. Then return to this page for
instructions on connecting the SCSI ribbon and power cables to
your drive(s).

Installing the SCSI Ribbon and Power Cables

This section explains how to connect SCSI ribbon and power
cables to your SCSI drive(s). The ribbon cable transmits data
and the power cable carries electric current to the SCSI device.
Installing the SCSI ribbon cable
The SCSI ribbon cable has seven connectors:
P6, P7,
and
P7
Note
The SCSI ribbon cable is designed so you can easily connect
up to six SCSI devices. You can attach the middle connectors
(P2
through
P7
attach
device you have defined as the last device on the bus.
7-22 Installing and Removing Disk Drives
as shown below.
P6)
to any SCSI drive. However, you must
(the last connector on the ribbon) to the SCSI
P1, P2 F3, P4, P5,