Table of Contents
Advertisement
Align the guiderails on each side of the drive with the
5.
notches on each side of the drive bay, as shown below.
Slide the drive into the bay as far as it will go.
6.
7. Secure the guiderails to the computer case with the two
screws you saved in step 4.
Connecting the Power Cables
Follow these steps to connect the IDE drive ribbon cable and
power cable to the drive:
1. Locate the connector at the end of the IDE drive ribbon cable.
Note
Make sure you connect a CD-ROM drive to the
secondary IDE interface; do not use the same cable for a
hard disk drive and a CD-ROM drive.
5-16 Installing and Removing Drives
Advertisement
Table of Contents
