Epson Powerspan 2 User Manual page 182

The computer starts but the screen is blank.
See "Monitor Problems" below.
The computer starts but does not boot.
If the computer starts but does not load your operating system,
the problem could be caused by many different factors.
First make sure you have correctly formatted your hard disk
and have properly installed your operating system on it. (See
"Hard Disk Problems" on page A-24.) Also be sure you enabled
the IDE hard disk drive controller and selected the correct drive
type in the SETUP program or the EISA Configuration utility.
If you do not have a hard disk, insert a system diskette in
drive A and press the reset button.
The computer does not respond when you type or click the
mouse.
If you have just turned on the computer, check the following:
Make sure your keyboard or mouse is securely connected
to the computer.
Make sure your keyboard and mouse are not locked. Check
the Keyboard/ Mouse Lock indicator to see if they are
locked. If so, press the Keyboard/ Mouse Lock button to
unlock them. See Chapter 4 for instructions.
If you entered the wrong password and cannot access your
system, see "Password Problems" below.
A-18 Troubleshooting