Epson Powerspan 2 User Manual page 125

If you are installing a high-resolution graphics adapter card
that connects to a VGA feature connector, follow the
instructions below to install the adapter card; then see "Using
the VGA Feature Connector" on page 6-10 to connect the card
to the VGA feature connector in your computer.
Follow these steps to install an option card:
If this is the first time you are installing a card in the option
slot, you need to remove the metal cover for that slot.
Remove the retaining screw securing the option slot cover
to the inside back panel. Keep the screw to secure the
option card to the computer.
Slide out the slot cover and set it aside. (Store it in a safe
place in case you remove the option card later.)
Unpack the option card and adjust any switches or jumpers
on it, if necessary. (Check the option card instructions.)
When you handle the card, be careful not to touch any of its
components or the gold connectors. If you need to set it
down before you install it, place it gently on top of its
original packing material with the component side facing
up. Keep the packing materials in case you remove the card
later.
Note
You may want to record the card's serial number in the
"Equipment Log" at the end of Chapter 1.
6-8 Installing and Removing Options