Epson Powerspan 2 User Manual page 157

5. Record the drive's model, serial, and SCSI ID number in the
"Equipment Log" on page 1-12.
6. Follow the instructions in the SCSI drive's documentation
to set any jumpers or switches on the drive and to install or
remove the terminating resistors.
Note
Do not remove terminating resistors from the SCSI
device you install at the end of the ribbon cable. The last
device on the cable terminates the SCSI bus and must
have terminating resistors installed.
7. Using two screws and a grounding clip, attach plastic slide
rail A to the right side of the drive; then use two screws and
a grounding clip to attach slide rail B to the left side.
Position each slide rail so its narrow end is at the socket end
of the drive with its tab facing outward, as shown below.
Then install a grounding clip under each of the two screws
nearest the narrow end of the slide rails.
7-20 Installing and Removing Disk Drives
slide rails
tab