Removing A Scsi Drive - Epson Powerspan 2 User Manual

Installing the SCSI power cables
Follow these steps to connect power cables to your SCSI
drive(s):
1. You can use
drives you have installed in the lower internal drive bays.
Position the power cable connector so that its notched
corners line up with the notched corners of the power
socket on the drive. Make sure the holes fit over all the pins
and then push in the connector.
2. Connect a power cable to each of the remaining drives in the
lower drive bays in the same manner.
3. If you installed a fifth or sixth SCSI drive in either the upper
internal bays or the external bay, connect power cables P6
and P7 to these drives.
Now see your SCSI drive documentation for instructions on
installing your SCSI drivers.

Removing a SCSI Drive

Before you remove any SCSI drive(s), check your SCSI drive
documentation for instructions on resetting the switches or
jumpers on your remaining drives and changing your
terminating resistors. Then follow these steps to remove the
drive(s) from your computer:
1. Disconnect the SCSI ribbon cable connector from the drive.
Grasp the pull tab and pull the connector straight out from
the socket so you do not bend the pins; do not pull on the
cable.
P8, P9, P10,
Installing and Removing Disk Drives
P11
or to provide power to any
7-25