Epson Powerspan 2 User Manual page 142

6. Hold the drive in front of the system and connect the power
cable to the drive. Position the cable connector so that its
holes fit over all the pins in the drive and then push in the
connector.
7. While holding the drive in front of the system, connect
the appropriate ribbon cable to the drive, as described
below.
If you are reinstalling a diskette drive in the top external
bay, use ribbon cable P3. Notice the small tab in the middle
of the cable connector; align this tab with the notch in the
drive's ribbon cable socket. Make sure the holes in the cable
connector fit over all the pins in the socket; then push in the
connector.
If you are installing a second diskette drive or other device,
use ribbon cable P2. Align the slot in the cable connector
with the gap in the drive's ribbon cable socket; then push in
the connector.
If you are installing a third drive, use the appropriate ribbon
cable that attaches to your drive's controller. Then connect
it as described in your drive documentation.
Installing and Removing Disk Drives 7-5