Epson Powerspan 2 User Manual page 61

System board options (continued)
Option
POST Memory
Test Prompt
POST Setup
Control
Boot Device
Control
Reserved
System
Resources
* Default setting
1 To boot your system from a SCSI hard disk drive, you must disable the
built-in IDE controller and set both hard disk drive types to Disabled.
2 You cannot set Serial Port 1 and 2 to the same address. If you attempt to
do so, you see an error message.
3 If you change the refresh rate, you must press the reset button or turn the
computer off and on again aftersaving your settings to reset the rate.
4 The Boot Device Control setting is ignored if the diskette drive iscontrolled
by a SCSI option card.
Settings
Enabled *
Disabled
Enabled -Prompt for
setup entry *
Enabled -Suppress
setup prompt
Setup Disabled
Boot from Diskette or
Hard Drive *
Boot from Hard Drive
Only
[settings vary]
Running the EISA Configuration Utility 3-19
Description
Set to Enabled to display the
skip memory test prompt when
you turn on or reset your
computer; select Disabled to
prevent display of the prompt
(You can still press the space-
bar to skip the test if you
disabled the prompt; see
Chapter 2)
Select Enabled -Prompt for
setup entry to display the
prompt to run the SETUP
program when you turn on or
reset the computer; select
Enabled -Suppress setup
prompt to prevent display of
the prompt; select Setup
Disabled to prevent entry into
the SETUP program until this
option is changed
Select the device(s) from
which you want to be able to
boot your system (4)
Press Enter and F6 to display
resources, such asinterrupts
and memory addressranges,
reserved for use by the system
board