Table of Contents
Advertisement
If you are unable to run the SETUP program or the EISA
Configuration utility, make sure you have write-enabled
your computer's FLASH memory. Check to see if jumper
E0721 is set to position 1-2, as described in Chapter 6.
If you are still having problems with your software, consult
your software documentation or contact the manufacturer
for technical support.
Printer Problems
Make sure the printer has power and is properly connected
to the computer. (Also, be sure your printer has paper in it.)
Check the printer manual for the printer's correct DIP
switch or control panel settings.
If you are using more than one parallel port or more than
one serial port, check the primary and secondary port
settings in the SETUP program or the EISA Configuration
utility to make sure they are correct. See Chapters 2 and 3
for instructions.
Option Card Problems
Make sure the option card is properly inserted in its slot.
Check the installation procedure described in Chapter 6
and also see the instructions that came with the card.
Be sure that you ran the SETUP program or the EISA
Configuration utility to update your configuration after
installing the card. See Chapters 2 and 3.
A-26 Troubleshooting
Advertisement
Table of Contents
