Table of Contents
Advertisement
Diskette Problems
Check to see if you inserted the diskette upside down or
did not insert it all the way.
If the diskette is blank, make sure it is formatted.
Place the diskette in the drive of another computer and
repeat the operation. If this works, the trouble may be in
your diskette drive. See "Diskette Drive Problems" below.
Make sure you enabled the built-in controller and selected
the correct diskette drive type(s) when you ran the SETUP
program or the EISA Configuration utility. See Chapters 2
and 3 for instructions.
If you cannot write to the diskette, make sure jumper
is set to position 2-3 to enable writes to the diskette drive.
See Chapter 6.
Diskette Drive Problems
If you think there is something wrong with your diskette drive,
check this section.
You see an error message or have difficulty with a diskette
drive.
If you removed your diskette drive and reinstalled it
yourself, review all the instructions in Chapter 7.
Be sure that you ran the SETUP program or EISA
Configuration utility to enable the built-in diskette drive
controller and set the correct diskette drive type. See
Chapters 2 and 3 for instructions.
If you are still having trouble with the drive, contact your
EPSON dealer or Authorized EPSON Servicer.
E0291
Troubleshooting
A - 2 3
Advertisement
Table of Contents
