Hard Disk Problems - Epson ExpressStation User Manual

Hard Disk Problems

If you think there is something wrong with your hard disk, see
the suggestions below.
You have problems with a newly-installed drive.
the problem.
carefully followed all the instructions in Chapter 3. Review
the procedures and check all the cable connections to make
sure you installed it correctly. Also check the jumper
settings on your drive to be sure they are set correctly.
you have set the appropriate SCSI ID number for the drive
and that you installed the terminators properly on the first
and last SCSI devices. See Chapter 4 and your SCSI drive
documentation for more information.
was physically formatted. This type of format is usually
done by the manufacturer; if yours was not, you must do it
yourself. If the drive came with its own format utility, use
that program; if not, follow the instructions in your
Guide.
Configuration utility to enable the appropriate built-in hard
disk controller and have defined your hard disk drive type
correctly. See your
prepared properly but you cannot access the drive, review
the instructions in your operating system manual. Make
sure you performed the necessary steps in the installation
process for your configuration.
Software Guide.
Troubleshooting
Software
A-15