Table of Contents
Advertisement
5.
If you installed a hard disk drive in one of the external bays,
replace the faceplate. Insert one side of the plate, then
gently press on the other side until it snaps into place.
After you have completed installation of the drive in the
external bay, you must replace the drive mounting bracket and
reconnect the cables. See page 4-8 for instructions.
Removing a Drive from an External Bay
To remove a drive from an external bay, follow these steps:
1.
Remove the drive mounting bracket. See page 4-2 for
instructions.
2.
Disconnect both the ribbon cable connector and the power
cable connector from the drive you are removing from the
external bay.
3.
Remove the screws securing the drive.
Installing and Removing Drives
4-21
Advertisement
Table of Contents
