Password; Ethernet Settings - MICRO-EPSILON capaNCDT 6228 Operating Instructions Manual

Ethernet Interface
6.8.3
Assigning passwords prevents unauthorized changes to controller settings. In the delivery state, no password
is deposited in the controller.
i
After the controller has been configured, you should enable password protection.

Password

With the first-time assignment of a password the Old Password field remains free.
6.8.4
The IP address of the controller is factory-set to 169.254.168.150. Communication with the controller is per-
formed via a data port (factory-set 10001) for measurement data transmission.
You can change the IP settings and the data port at any time:
- using the web browser,
- using the sensorTOOL Software.
Address type
Grey shaded
IP address
fields require a
Netmask
selection.
Gateway
Dark-bordered MAC address
fields require
UUID
Value
you to specifie
Data port
a value.
capaNCDT 6228 / 6238
Password
A firmware update will not change the custom password.
Change to the menu Settings > System settings > Change password.
Value

Ethernet Settings

Menu Settings > System settings > Settings Ethernet.
static IP address /
Dynamic (DHCP)
Value
Value
Value
Value
Value
Value
All passwords are case-sensitive. Letters and numbers are allowed, but
special characters are not permitted.
A password consists of max. 16 characters.
When using a static IP address it is necessary to enter the values for
the IP address, netmask and gateway; this is not required when DHCP
is used. When DHCP is activated, the controller is accessible in the
network under its DHCP Host name. It contains the name and serial
number and is unchangeable, see Chap. 6.5.1.
With DHCP it may be necessary to enable the controller MAC address.
Setting the port on the measurement value server
Page 76