Removing The Air Filter; Removing Cable Management Brackets And Mounting Brackets (Only For The Cr16014-F Router) - H3C CR16000-F Installation Manual

Removing the air filter

1. Prepare the packing bag of the air filter. Make sure the bag is clean, dry, and not damaged.
2. Remove the air filter from the side of the chassis.
For information about how to remove an air filter, see "Replacing an air filter."
3. Put the air filter into the bag.
Removing cable management brackets and mounting
brackets (only for the CR16014-F router)
Before repackaging the CR16014-F router chassis, remove the cable management brackets and
mounting brackets from the chassis.
Removing the mounting brackets
1. Prepare the packing box of the mounting brackets. Make sure the box is clean, dry, and not
damaged.
2. As shown in
brackets to the chassis, and then remove the mounting brackets.
3. Put the mounting brackets into the box.
Figure 3 Removing the mounting brackets from the chassis
2
Removing the cable management brackets
1. Prepare the packing bag of the cable management brackets. Make sure the bag is clean, dry,
and not damaged.
2. Use a Phillips screwdriver to loosen the screws that attach the cable management brackets to
the chassis, and then remove the cable management brackets.
Figure 3, use a Phillips screwdriver to loosen the screws that attach the mounting
1
1
2
4