H3C CR16000-F Installation Manual page 34

6. Hold the card by the front panel with one hand and support the card bottom with the other. Slide
the card steadily into the slot along the guide rails.
7. When most part of the card is inserted in the slot, pull the ejector levers on the card outward.
8. Push the card until the positioning pin on card touches the hole on the chassis.
9. Press the ejector levers inward until the ejector levers touch the panel tightly and the card seats
into the backplane
10. Push the ejector levers up to its original position. (This step applies only to ejector levers similar
to those on a CSPEX-1504X card.)
11. Close the locking clip or micro switch, if any, on the module.
12. Fasten the captive screws on the card.
13. When the router is powered on, check the running status of the card.
You can determine the running status of a card by observing the card status LED (SLOT) on the
MPU of the router. If the RUN LED blinks, the card in the slot operates correctly. For more
information about card status LED (SLOT), see H3C CR16000-F Router Series Hardware
Information and Specifications.
Figure 3 Installing a universal card
2
3
1
3
4