H3C CR16000-F Installation Manual page 50

RJ-45 pin
5
6
7
8
•
Console cable connecting the USB console port on a router and the USB port on a terminal
The console cable has one USB 5-pin mini-Type B connector for connecting to the USB
console port of the router and one USB Type-A connector for connecting to the USB port of the
terminal.
Figure 2
Figure 2 Console cable connecting the USB port and the USB console port
Table 2 Pinouts for the console cable connecting the USB port and the USB console
port
USB A pin
1
2
3
4
Connecting the console port to the terminal
IMPORTANT:
• Identify the marks on the console port and USB console port, and make sure you are connecting
to the correct port.
• The serial ports on PCs do not support hot swapping. To connect a PC to an operating device,
first connect the PC end. To disconnect a PC from an operating device, first disconnect the
device end.
To connect the console cable to the console port:
1. Connect the DB-9 connector of the console cable to the serial port on a PC or terminal.
2. Connect the RJ-45 connector of the console cable to the console port on the MPU of the router.
To connect the console cable to the USB console port:
1. Connect the USB-A connector of the console cable to the USB port on a PC or terminal.
2. Connect the mini-USB A/B connector of the console cable to the USB console port on the MPU
of the router.
Signal
GND
RXD
DSR
CTS
shows the console cable and
USB Type-A
Signal
VBUS
D-
D+
GND
DB-9 pin
5
3
4
7
Table 2 shows its pinouts.
USB 5-pin mini-Type B
mini-USB A/B pin
1
2
3
4
5
2
Signal
SG
TXD
DTR
RTS
Signal
VBUS
D-
D+
ID(NC)
GND