H3C CR16000-F Installation Manual page 93

Figure 3 Cutting the cable ties
•
Route, bind, and attach excess cables for easy, safe maintenance activities and proper
operations.
•
Do not tie the power cords to the slide rails.
•
When you connect a cable to an articulated part, for example, when you connect a grounding
cable to a rack door, leave enough slack in cables and make sure they are not stressed from
any movement of the part.
•
Cables must be protected at points where they might rub or come in contact with sharp edges or
heated areas. Use high temperature cables near heat sources.
•
Fasten heavy or rigid power cords at the connectors to relief stress.
Cable management
The devices in the following figures are for illustration only.
3