Removing Boost Compensator (Equipped With R24 Model) - Kubota WSM 05-E4B Series Workshop Manual

SERVICING
5. Disassembling and assembling
(1) Gear case
[A] Gear case for standard oil
pan
[B] Gear case for extended oil
pan
[C] Gear case for BG type (Ex-
cept D1305-E4BG)
(a) Bolt length = 45 mm (1.8 in.)
(b) Bolt length = 50 mm (2.0 in.)
(When reassembling)
• Grease thinly to the oil seal, and install it, ensuring
the lip does not come off.
5.16 Removing boost compensator
(equipped with R24 model)
IMPORTANT
• Use the stop solenoid mounting bolt (3) for the
dropout prevention of boost compensator (2)
and the damage prevention of the guide (6)
when remove the boost compensator.
• The guide (6) of boost compensator and the
control rack (7) should be made the level when
you install boost compensator assembly.
05-E4B SERIES,05-E4BG SERIES
(c) Bolt length = 55 mm (2.2 in.)
(d) Bolt length = 65 mm (2.6 in.)
(e) Bolt length = 68 mm (2.7 in.)
(f) Bolt length = 70 mm (2.8 in.)
(g) Bolt length = 85 mm (3.3 in.)
(h) Nut
(j) Bolt length = 59 mm (2.3 in.)
(k) Bolt length = 82 mm (3.2 in.)
(2) Boost compensator assem-
bly
(3) Stop solenoid mounting bolt
1. Disconnect the hose (4).
2. Remove the stop solenoid mounting bolt (M6 ×
87 mm) (3).
3. Remove the stop solenoid (1).
4. Install the stop solenoid mounting bolt (3) in an
original position again.
5. Remove the boost compensator mounting bolt (5).
6. Remove the boost compensator assembly (2).
4. ENGINE
(6) Guide
(7) Control rack
4-37
KiSC issued 03, 2023 A