Servicing; Checking Cylinder Head Top Clearance - Kubota WSM 05-E4B Series Workshop Manual

SERVICING

6. Servicing
11. Remove the plunger (11).
(1) Through bolt
(2) Brush
(3) C terminal nut
(4) Yoke
(When reassembling)
• Apply grease (DENSO No. 50 or equivalent) to the idle gear and overrunning clutch portions.
• Tighten to the specified tightening torque.
Tightening torque
6. Servicing
6.1 Checking cylinder head top
clearance
Tools required
• Plastigauge
1. Remove the cylinder head.
2. With the piston at T.D.C., use grease to affix three
or four plastigauges (1) to the crown of the piston;
keep the gauges away from the intake valve and
combustion chamber fittings.
05-E4B SERIES,05-E4BG SERIES
(5) Armature
(6) Overrunning clutch
(7) Idle gear
(8) End frame
B terminal nut
(9) Brush holder
(10) Magnet switch cover
(11) Plunger
(12) B terminal nut
5.88 to 11.8 N⋅m
0.600 to 1.20 kgf⋅m
4.34 to 8.70 lbf⋅ft
Diameter
Plastigauge (1) cut
size
Length
4. ENGINE
(13) Housing
1.5 mm
0.059 in.
5.0 to 7.0 mm
0.20 to 0.27 in.
4-49
KiSC issued 03, 2023 A