Replacing Fuel Hoses And Clamp Bands - Kubota WSM 05-E4B Series Workshop Manual

3. MAINTENANCE
4. Replace with the new upper / lower hose (1), (2)
and clamp bands.
(1) Upper hose
5. Tighten the clamp bands.
6. Fill with clean water and anti-freeze until the coolant
level is just below the port. Install the radiator cap
securely.
13.4 Replacing fuel hoses and clamp
bands
CAUTION
• Stop the engine when checking and changing
the fuel hose.
1. Loosen the clamp (2) and remove the fuel hose (1).
2. Replace with the new fuel hose (1) and new clamp
(2).
3. Tighten the clamp (2).
3-20
(2) Lower hose
CHECK AND MAINTENANCE
13. Check points of every 2 years
(1) Fuel hose
(2) Clamp
[A] Cartridge type
(When bleeding fuel system)
NOTE
• Always keep the air vent valve on the fuel
injection pump closed except when air is
vented, or it may cause the engine to stop.
1. Fill the tank with fuel and open the fuel valve (4).
2. Loosen the air vent plug (3) of the fuel filter a few
turns.
(3) Air vent plug
(4) Fuel valve
[A] Cartridge type
3. Screw back the plug when bubbles do not come up
any more.
[B] Element type
[B] Element type
05-E4B SERIES,05-E4BG SERIES
KiSC issued 03, 2023 A