Removing Flywheel; Removing Bearing Case Cover - Kubota WSM 05-E4B Series Workshop Manual

SERVICING
5. Disassembling and assembling

5.24 Removing flywheel

1. Secure the flywheel to keep it from turning, using a
flywheel stopper.
2. Remove all flywheel screws (1) and then remove
the flywheel (2).
(1) Flywheel screw
(When reassembling)
• Align the "1TC" mark (a) on the outer surface of the
flywheel horizontally with the alignment mark (b) on
the rear end plate. Now fit the flywheel in position.
(a) 1TC mark
• Apply engine oil to the threads and the undercut
surface of the flywheel screw and fit the screw.
• Tighten to the specified tightening torque.
Tightening tor-
Flywheel screw
que

5.25 Removing bearing case cover

IMPORTANT
• The length of inside screws (1) and outside
screws (2) are different. Do not teke a mistake
using inside screws and outside screws.
05-E4B SERIES,05-E4BG SERIES
(2) Flywheel
(b) Alignment mark
54 to 58 N⋅m
5.5 to 6.0 kgf⋅m
40 to 43 lbf⋅ft
(1) Bearing case cover mount-
ing screw (Inside) (Long)
(2) Bearing case cover mount-
ing screw (Outside) (Short)
1. Remove the bearing case cover mounting screws.
2. Remove the bearing case cover (6).
(3) Bearing case gasket
(4) Bearing case cover gasket
(5) Oil seal
(When reassembling)
• Fit the bearing case gasket (3) and the bearing
case cover gasket (4) with correct directions.
(3) Bearing case gasket
(4) Bearing case cover gasket
• Install the bearing case cover (6) to position the
casting mark "UP" on it upward.
4. ENGINE
(a) Top mark "UP"
(6) Bearing case cover
(b) Upside
4-43
KiSC issued 03, 2023 A