Flywheel And Crankshaft - Kubota SM-E4B Series Workshop Manual

Table of Contents

Advertisement

SM-E4B SERIES, WSM

(6) Flywheel and Crankshaft

Flywheel
1. Secure the flywheel to keep it from turning using a flywheel
stopper. (Refer to "SPECIAL TOOLS".)
2. Remove all flywheel screws (1) and then remove the flywheel
(2).
(When reassembling)
• Set the No. 1 crankpin at the top dead center (T.D.C.).
• Align the "1TC" mark (a) on the outer surface of the flywheel
horizontally with the alignment mark (b) on the rear end plate.
• Apply engine oil to the threads and the undercut surface of the
flywheel screw and fit the screw.
Tightening torque
Flywheel screw
(1) Flywheel Screw
(2) Flywheel
Bearing Case Cover
1. Remove the bearing case cover mounting screws. First, remove
inside screws (1) and then outside screws (2).
2. Remove the bearing case cover (5).
(When reassembling)
• Fit the bearing case gasket (3) and the bearing case cover
gasket (4) with correct directions.
• Install the bearing case cover (5) to position the casting mark
"UP" (a) on it upward.
• Apply engine oil to the oil seal (6) lip and take care that it is not
rolled when installing.
• Tighten the bearing case cover mounting screws with even
force on the diagonal line.
Bearing case cover
Tightening torque
mounting screw
(1) Bearing Case Cover Mounting
Screw (Inside)
(2) Bearing Case Cover Mounting
Screw (Outside)
(3) Bearing Case Gasket
(4) Bearing Case Cover Gasket
(5) Bearing Case Cover
(6) Oil Seal
1-S43
ENGINE
54 to 58 N·m
5.5 to 6.0 kgf·m
40 to 43 lbf·ft
(a) 1TC Mark
(b) Alignment Mark
9Y1210785ENS0052US0
9.81 to 11.2 N·m
1.00 to 1.15 kgf·m
7.24 to 8.31 lbf·ft
(a) Top Mark "UP"
(b) Upside
9Y1210785ENS0053US0
KiSC issued 01, 2013 A

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents