Inlet And Exhaust Valves; Flywheel - Kubota WG1605-G-E3 Workshop Manual

WG1605-G-E3,WG1605-L-E3,WG1605-GL-E3, WSM

[12] INLET AND EXHAUST VALVES

[13] FLYWHEEL

The valve and its guide for the inlet are different from
those for the exhaust.
Other parts, such as the spring (4), spring retainer
(3), collet (2), stem seal (5), and cap (1) are the same for
both the inlet and exhaust.
(1) Valve Cap
(2) Collet
(3) Spring Retainer
(4) Spring
The flywheel (1) is connected with the crankshaft, it
stores the rotating force in the combustion stroke as
inertial energy to rotate the crankshaft smoothly.
The flywheel periphery is provided with marks
showing fuel injection timing and top dead center.
The flywheel has gear teeth around its outer rim,
which mesh with the drive pinion of the starter. Also, a
rotor for determining the ignition timing is attached to the
flywheel.
(1) Flywheel
1-M5
ENGINE
(5) Stem Seal
(6) Valve Guide
(7) Inlet Valve
(8) Exhaust Valve
9Y1210661ENM0028US0
9Y1210661ENM0032US0
KiSC issued 01, 2012 A