5 Installation and Wiring
2
Leave the flat-blade screwdriver pressed into the release hole and insert the twisted wire or the
solid wire into the terminal hole.
Insert the twisted wire or the solid wire until the stripped portion is no longer visible in the termi-
nal hole to prevent shorting.
3
Remove the flat-blade screwdriver from the release hole.
After you make a connection, lightly pull the twisted wire or the solid wire to make sure that the wire
is securely connected to the terminal block.
5-44
Release hole
2
Twisted wire/Solid wire
3
NX-series NX102 CPU Unit Hardware User's Manual (W593)
Flat-blade screwdriver
1
10 to 15°