Installing And Removing The Sd Memory Card - Omron NX Series Hardware User Manual

l Using CLIPFIX 35 (Phoenix Contact)
To mount an End Plate, 1) hook the top of it on the top of the DIN Track and 2) rotate the Plate to
hook the bottom of it on the bottom of the DIN Track. Press in until you hear the End Plate lock into
place.
To remove an End Plate 1) insert the tip of a flat-blade screwdriver into groove "a" and 2) use "b" as
a fulcrum and lift the end of the screwdriver, as shown in the following diagram.
2)
Flat-blade screwdriver
5-3-8

Installing and Removing the SD Memory Card

Before Using an SD Memory Card
• Keep the following precautions because an SD Memory Card may become unusable.
a) Do not turn OFF the power supply to the Controller while the SD BUSY indicator is lit (i.e., while
SD Memory Card access is in progress).
The SD BUSY indicator is lit when the SD Memory Card is accessed from the user program or
from a computer through FTP.
b) Do not remove the SD Memory Card while the SD BUSY indicator is lit or the SD PWR indicator
is lit (i.e., while SD Memory Card power is supplied).
Press the SD Memory Card power supply switch and confirm that the SD BUSY indicator or SD
PWR indicator is not lit before you remove the SD Memory Card.
• Never insert the SD Memory Card facing the wrong way.
If the SD Memory Card is inserted forcibly, it may become unusable.
• To format the SD Memory Card (e.g., to delete all of the data), insert the SD Memory Card in the
CPU Unit and perform the operation from the Sysmac Studio.
• The SD Memory Card uses flash memory, and so its service life is limited. When the end of the SD
Memory Card's service life approaches, the ability to write data is lost, and data is sometimes not
retained after writing. The service life depends on the size of the data that is written and on the
NX-series NX102 CPU Unit Hardware User's Manual (W593)
1)
2)
b
a
1)
5 Installation and Wiring
5-23
5