NEC PA1705UL-W Installation Manual page 174

Turning On the Projector by Detecting Input Signal [AUTO POWER ON SELECT]
Under the state of standby or sleep, the projector automatically detects and projects synchroniz-
ing signal input from the selected terminals among [HDMI1], [HDMI2], [HDBaseT] and [SDI] by this
function.
OFF
HDMI1, HDMI2, HDBaseT, SDI When the projector detects the signal input from the selected terminal, automatically it will be
WARNING
• The projector produces intense light. When the power is turned on, make sure no one within
the projection range is looking at the lens.
NOTE:
• If you want to activate this [AUTO POWER ON SELECT] function after powering OFF the projector, interrupt the signal from the input
terminals or disconnect the computer cable from the projector and wait for more than 3 seconds (1 minute or longer if the input
signal is HDBaseT) and then the input signal from the selected terminal. In addition, if signal is continuously input to the projector,
the projector may be turned ON again automatically based on the setting of external devices even if the projector is turned OFF
and in the condition of SLEEP mode.
• When the projector is in standby, only the HDMI1 IN or HDMI2 IN input signals will be detected and projected.
Enabling Power Management [AUTO POWER OFF]
When this option is selected you can enable the projector to automatically turn off (at the selected
time: 0:05, 0:10, 0:15, 0:20, 0:30, 1:00) if there is no signal received by any input or if no operation
is performed.
Using Off Timer [OFF TIMER]
1. Select your desired time between 30 minutes and 16 hours: OFF, 0:30, 1:00, 2:00, 4:00, 8:00,
12:00, 16:00.
2. Press the ENTER button on the remote control.
3. The remaining time starts counting down and it is displayed at the bottom of the On-Screen
Menu.
4. The projector will turn off after the countdown is complete.
NOTE:
• To cancel the preset time, set [OFF] for the preset time or turn off the power.
• When the remaining time reaches 3 minutes before the projector is turned off, the [THE PROJECTOR WILL TURN OFF WITHIN 3
MINUTES.] message will be displayed on the bottom of the screen.
[AUTO POWER ON SELECT] function becomes inactive.
turned [ON] and will project the screen.
139
5. Using On-Screen Menu