NEC PA1705UL-W Installation Manual page 168

[SERVICES]
HTTP SERVER Configure the settings for connecting to the HTTP server.
Enter the USER NAME and PASSWORD that have been set at [ACCOUNT].
PJLink Configure the settings for using PJLink.
AMX BEACON Turn on or off for detection from AMX Device Discovery when connecting to the
network supported by AMX's NetLinx control system.
[ON] will enable detecting the projector from AMX Device Discovery..
[OFF] will disable detecting the projector from AMX Device Discovery.
CRESTRON ROOMVIEW: Turn on or off when controlling the projector from your PC.
CRESTRON CONTROL: Turn on or off when controlling the projector from your
controller.
• CONTROLLER IP ADDRESS: Enter your IP address of CRESTRON SERVER.
• IP ID: Enter your IP ID of CRESTRON SERVER.
ON Connect directly to the HTTP server without displaying the
login screen.
OFF It is not possible to connect to the HTTP server.
AUTH. Display the login screen when connecting to the HTTP server.
NEW Set the password.
PASSWORD,
CONFIRM
PASSWORD
CLASS Switches between Class 1 and Class 2.
DESTINATION When the [CLASS] is set to [CLASS2], input the IP address of
the destination.
NOTE:
• Do not forget your password. However, if you forget your password, consult
with your dealer.
• What is PJLink?
PJLink is a standardization of protocol used for controlling projectors of dif-
ferent manufacturers. This standard protocol is established by Japan Business
Machine and Information System Industries Association (JBMIA) in 2005.
• Setting of PJLink will not be affected even when [RESET] is done from the
menu.
TIP:
• When using a device that supports AMX Device Discovery, all AMX NetLinx
control system will recognize the device and download the appropriate Device
Discovery Module from an AMX server.
TIP:
• The CRESTRON settings are required only for use with CRESTRON ROOMVIEW.
For more information, visit https://www.crestron.com
133
5. Using On-Screen Menu
—
Up to 32 alphanumeric
characters
—
Up to 12 numeric
characters