NEC PA1705UL-W Installation Manual page 162

Assigning or Changing the Control ID
1. Turn on the projector.
2. Press the ID SET button on the remote control.
The [CONTROL ID] screen will be displayed.
If the projector can be operated with the current remote control
ID, the [ACTIVE] will be displayed. If the projector cannot be oper-
ated with the current remote control ID, the [INACTIVE] will be
displayed. To operate the inactive projector, assign the control ID
used for the projector by using the following procedure (Step 3).
3. Press one of numeric keypad buttons while pressing and
holding the ID SET button on the remote control.
Example:
To assign "3", press the "3" button on the remote control.
No ID means that all the projectors can be operated together
with a single remote control. To set "No ID" and cancel the con-
trol ID setting, enter "000" or press the number 0 while holding
down the ID SET button.
TIP:
• The range of IDs is from 1 to 254.
4. Release the ID SET button.
The updated [CONTROL ID] screen will be displayed.
NOTE:
• The IDs can be cleared in a few days after the batteries are run down or removed.
• Accidentally pressing any one of the buttons of the remote control will clear cur-
rently specified ID with batteries removed.
127
5. Using On-Screen Menu
X