Star Micronics TSP400 Series Programmer's Manual page 47

Enable cutter(applicable only for TSP442)
FUNCTION
CODE
<ESC> "B
1B
HEX
This command defines cut position and enables cutter. This
REMARKS
command does not energize cutter.
Cutter will be operated only when receiving<ESC> "I" com-
mand.
d
n1n2
Note:
+ 2.5 mm from the edge of print area.
EXAMPLE
LPRINT CHR$(&H1B);"B+25";CHR$(&H0A);CHR$(&H00);
Set Memory Switch
FUNCTION
CODE <ESC>
1B
HEX
Set the memory switch. In order to enable changed memory switch
REMARKS
settings, turn the printer OFF and ON again or send printer reset
command (<ESC>"?") to the printer. Changed memory switch
settings are stored in EEPROM and these setting will be stored as
long as the time when they are changed again.
N
n1n2n3n4 : Mode settings (For details see below)
1) Use N=1 to set printer conditions. Parameters are as follows.
d n1n2" <LF><NUL>
42 d n1n2 0A
: "+" or "-" indicates the direction of the cut position
from the normal position.
"+" indicates a forward feed, and "-" indicates a
reverse feed from the normal cut position.
: Indicates the value to move in 1/10 mm unit.(00 to 50)
a) If these parameters (d and n1n2) are omitted, then the
cut position is set at the default position.
b) Default cut position , or normal position, is at the
bottom edge of the print area.
c) This command is only applicable when cutter is
installed. (model TSP442 only)
"# N
23 N
: Memory switch number (1 or 2)
n1 : Sensor select
n2 : Start-position detect
n3 : Zero style
n4 : International character set
– 44 –
00
, n1n2n3n4"<LF> <NUL>
2C n1n2n3n4 0A 00