Star Micronics TSP400 Series Programmer's Manual page 42

This command stores graphic data into image memory.
REMARKS
x1x2x3x4 : Print start position in the X direction. (0000 to 0800
y1y2y3y4 : Print start position in the Y direction. (0000 to 3000
|1|2|3|4
w1w2w3 : Defines the width (X direction) of the graphic area.
n11....nmk:n11 represents data in the 1st line. Each line ends with
Note:
Position of starting point (X,Y) direction : (30,40) mm
EXAMPLE
Size of image data (X,Y) direction : (3,3) mm, (|1|2|3|4 = 3 8 =
0024 bytes, w1w2w3 = 3
LPRINT CHR$(&H1B);"Q;0300,0400,0024,003,";
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
CHR$(&H01);CHR$(&H02);CHR$(&H03);CHR$(&H0A);
0.1 mm)
0.1 mm)
: Defines the length (Y direction) of the graphic area.
(0001 to 2400 dots)
(010 to 080 dots)
<LF>.
Data (X direction) appears in the same way as bit
image data. n21 represents data in the 2nd line.
a) This command can be used any number of times.
b) Size of graphic data is set in 1 mm units (byte units
(8 bits/bytes)) in the X direction and 0.125 mm units
(dot units) in the Y direction.
c) <ESC> "X" cancels data that was set using the
command.
d) If ";" or "," is missing, printer goes into an error
condition.
1 = 003 dots)
– 39 –