Star Micronics TSP400 Series Programmer's Manual page 96

Set select mode
FUNCTION
When using serial interface printer;
CODE <DC1> or <DC1> n
(11)H
HEX
When using parallel interface printer
CODE
<DC1>
(11)H
HEX
(1) When using serial interface printer;
REMARKS
This function differs depending on the setting of the DIP
switch 4.
a) When the DC1, DC3 invalid mode is set (DIP switches 2-
b) In the DC1, DC3 valid mode (with DIP switches 4-1 to 4-
c) If the printer receives a <DC1>n code (n is the DIP switch
(2) When using parallel interface printer;
When the printer receives a <DC1> code, the deselect mode is
canceled and data following this code is input to the buffer.
Beep the buzzer
FUNCTION
CODE <RS>
1E
HEX
Sounds a brief beep tone.
REMARKS
or (11)H n
1 to 2-4 are all set to ON), the printer ignores this code.
4 set to OFF), when the printer receives a <DC1> code, the
deselect mode is canceled and data following this code is
input to the buffer.
controlled address) during the addressable mode (with DIP
switches 2-1 to 2-4 set other than settings a) and b) above,),
the deselect mode is canceled and data following this code
is input to the buffer.
Note that addressable mode is valid only when optional RS-
422A interface is installed.
– 93 –