Star Micronics TSP400 Series Programmer's Manual page 33

Define ruled line format
FUNCTION
CODE
<ESC> "L n1n2 ;
y5y6y7y8 , d , w" <LF> <NUL>
1B
HEX
y5y6y7y82C d 2C w
This command defines ruled line format.
REMARKS
n1n2
x1x2x3x4 : Position of the starting point in the X direction (0000
y1y2y3y4 : Position of the starting point in the Y direction (0000
x5x6x7x8 : Position of the ending point in the X direction (0000
y5y6y7y8 : Position of the ending point in the Y direction (0000
These four parameters work in 1/10 mm unit, and should be given
with four digit numbers.
d
w
Note:
Line number: 00
EXAMPLE
Position of the starting point (X,Y) direction: (3.3)mm
Position of the ending point (X,Y) direction: (72.3)mm
Line direction
LPRINT CHR$(&H1B);"L00;0030,0030,0720,0030,0,5";
CHR$(&H0A); CHR$(&H00);
x1x2x3x4 , y1y2y3y4 , x5x6x7x8 ,
4C n1n2 3B x1x2x3x4 2C y1y2y3y4 2C x5x6x7x8 2C
0A
: Line number(00 to 63)
to 0800 0.1 mm)
to 0300 0.1 mm)
to 0800 0.1 mm)
to 0300 0.1 mm)
: Line direction
When d=0, then y1y2y3y4 = y5y6y7y8. When d=1,
then x1x2x3x4 = x5x6x7x8.
: Line width 1 to 9 dots
a) This command is used to define lines for label fram-
ing.
b) Up to 64 lines can be defined.
c) Lines must be vertical or horizontal (no diagonal
line).
d) The width of one dot is about 0.125 mm, and so four
dots make 0.5 mm width.
:Horizontal line, Line width 5 dots (0.625 mm)
– 30 –
00
d=0 : Horizontal line
d=1 : Vertical line