Star Micronics TSP400 Series Programmer's Manual page 46

Other commands
Print Label
FUNCTION
CODE <ESC> "I" <LF><NUL>
1B
HEX
This command print out one label according to the previously
REMARKS
defined format and data.
LPRINT CHR$(&H1B);"I";CHR$(&H0A);CHR$(&H00);
EXAMPLE
Set Feed Length after Printing
FUNCTION
CODE
<ESC> "T
1B
HEX
This command sets paper feed length after printing. Paper feed is
REMARKS
executed only the printer receives<ESC> "I" command.
This command is designed to adjust distance between print head
and paper tear off bar(applicable only for TSP412)
Feed paper will be feed back again for same length right before
next printing starts.
d
n1n2
Note:
Feed paper length from tear bar: +2.5 mm
EXAMPLE
LPRINT CHR$(&H1B);"T+25";CHR$(&H0A);CHR$(&H00);
49 0A 00
d n1n2" <LF><NUL>
54 d n1n2 0A
: "+" or "-" indicates the direction of the paper feed
length from the tear bar.
"+" indicates a forward feed, and "-" indicates a
reverse feed.
: Indicates the value to move with 1/10 mm unit. (00 to
50)
a) If parameters (d and n1n2) are omitted, then paper
feed is to the default position.
b) Feeds paper to the tear bar and stops until next
<ESC> "I" command, then reverse feeds and prints.
– 43 –
00