Table of Contents
Advertisement
Manual
MS-00809-0100-0470
3.12
Connecting to Ethernet ports
The Rosemount 470XA has two Ethernet ports that can be configured with unique Internet
protocol (IP) addresses, subnet masks, and gateway addresses.
Figure 3-14: Ethernet ports on the backplane
A. Ethernet 2
B. Ethernet 1
C. DHCP switch
•
Ethernet 1 is an RJ-45 connector designed to accept common Ethernet cable
connections found on computers and other Ethernet enabled devices and is primarily
intended for local connection to a computer, but can also be permanently connected to
other Ethernet devices.
•
Ethernet port 2 is a field terminated port primarily intended for connection to
supervisory systems or other Ethernet enabled devices.
•
Both ports can be used for Modbus
Rosemount MON2020 configuration and diagnostics software.
Rosemount 470XA
•
Backplane location: TB5
•
Terminal type: Wired
•
Backplane location: J9
•
Terminal type: RJ-45, DHCP-enabled
•
Backplane location: SW1
TCP communication and communication to the
®
Installation
June 2023
45
Advertisement
Table of Contents
