Manual
MS-00809-0100-0470
Figure 4-13: New Module Software Assistant
NOTICE
You can initiate the New Module software assistant from the local operator interface (LOI)
or MON2020 by selecting Module Validation on the Tools menu.
NOTICE
Changing the CPU board will also start the New Module software assistant because of the
mismatch between the CPU board and the analytical module. In this case, you should stop
the assistant by pressing
While the GC is heating up to temperature, the LOI shows the Calibration Gas Info
composition screen so that you can confirm that the module's calibration gas values match
the concentrations and the uncertainty on the calibration gas bottle certificate.
Rosemount 470XA
.
Using the Rosemount 470XA
June 2023
99