Spectra Logic Spectra S50 User Manual page 71

Table 15-2: Library SCSI Error Codes
Sense Key ASC
5h
Illegal
Request
00h
1Ah
20h
21h
24h
25h
26h
26h
26h
26h
26h
26h
Chapter 15. Error Reporting
ASCQ Error Description
Operation in progress.
The initiator is trying to initiate an
16h
additional command to the target
device before the first command is
complete.
00h Parameter list length error.
00h Invalid command code.
01h Invalid element address.
00h Invalid field in CDB.
00h LUN not supported.
00h Invalid field in parameter list.
01h Parameter not supported.
02h Parameter value invalid.
06h Too many target descriptors.
Unsupported target descriptor type
07h
code.
08h Too many segment descriptors.
Explanation or Error Remedy
The initiator cannot send more than one
tape movement command at a time.
1. Wait for the previous command to
complete.
2. Stop all software and reset the devices
involved.
3. Verify connectivity of the device before
proceeding.
4. Power cycle the device to stop the error;
also stop and restart the program, daemon,
or services involved.
The number of SCSI mode parameters
passed differs from the number required.
The command code received is not
supported or not a valid command. Verify
that the attempted command is supported,
then retry the command.
The command contained an invalid element
address for this logical library.
A field in the command descriptor block was
not a valid value.
The requested logical unit is not supported.
A parameter field was sent with an invalid
value.
The parameter in the SCSI CDB is not
supported. Verify that the command issued
is a valid command.
A parameter in the CDB has a value that is
out of range. Verify that the command issued
is a valid command.
Verify that the command issued is a valid
command.
Contact Technical Support.
71