Replacing Engine Oil - Hisun HS 250UTV Owner's/Operator's Manual

Introduction HS 200UTV/HS 250UTV
■Replacing Engine Oil Filter
CAUTION
To avoid personal injury:

Be sure to stop the engine before
changing the oil filter cartridge.

Allow engine to cool down sufficiently,
oil can be hot and can burn.
1. Park the vehicle on a flat surface and raise
the cargo bed.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber
seal of the new filter.
4. After the new filter has been replaced, the
engine oil normally decreases a little. Make
sure that the engine oil does not leak
through the seal and check the oil level on
the dipstick. Then replenish the engine oil
up to the prescribed level.
[1] Engine oil filter
[2] Bolt
IMPORANT:

To prevent serious damage to the engine,
use only a genuine filter.
1-45