Table of Contents
Advertisement
Introduction HS 200UTV/HS 250UTV
STORAGE
CAUTION
To avoid personal injury:
Do not clean the vehicle when the engine is running.
To avoid the danger of exhaust fume poisoning, do
not operate the engine in a closed building without
proper ventilation.
When storing, remove the key from the key switch to
avoid unauthorized persons from operating the
vehicle and getting injured.
VEHICLE STORAGE
If you intend to store your vehicle for an extended period of
time, follow the procedures outlined below.
These procedures will insure that the vehicle is ready to
operate with minimum preparation when it is removed from
storage.
1.
Check the bolts and nuts for looseness and tighten if
necessary.
2.
Apply grease to vehicle areas where bare metal will rust
also to pivot areas.
3.
Unload from cargo bed.
4.
Inflate the tire to a pressure a little higher than usual.
5.
Change the engine oil and run the engine to circulate oil
throughout the engine block and internal moving parts
for about 5 minutes.
6.
With all implements lowered to the ground, coat any
exposed rods with grease(if equipped).
4.
Check all fluid levels(engine oil, transmission oil, engine
coolant,
transmission
implements).
5.
Start the engine. Observe all gauges. If all gauges are
functioning properly and reading normal, move the
vehicle outside. Once outside, park the vehicle and let
the engine idle for at least five minutes. Shut the engine
coolant
and
any
1-53
7.
Remove the battery from
the
battery following the battery
storage procedures.
8.
Keep the vehicle in a dry
place where the vehicle is
sheltered
elements.
vehicle.
9.
Keep the vehicle indoors in
a dry area that is protected
from sunlight and excessive
heat. If the vehicle must be
stored outdoors. Cover it
with a waterproof tarpaulin.
Put boards under the tires
to keep dampness away
from tire.
Keep the tries out of direct
sunlight and extreme heat.
IMPORTANT:
When washing the vehicle,
be sure to stop the engine.
Allow sufficient time for the
engine
washing.
Do not wash with a high-
pressure
machine.
Cover the vehicle after the
attached
muffler and the engine have
cooled down.
REMOVING
VEHICLE
vehicle.
Store
the
from
the
Cover
the
to
cool
before
car-washing
THE
FROM
Advertisement
Table of Contents
