Engine And Other Check - Hisun HS 250UTV Owner's/Operator's Manual

Introduction HS 200UTV/HS 250UTV
2. Set gear shift lever to the "NEUTRAL"
position.
3. Push the accelerator pedal down
slowly.
① Accelerator pedal
② Accelerator pedal depressed
1. Insert the key into the key switch and turn
it to :
"START"
(Starts the Engine)
OFF (Stops the Engine)
ON (Engine runs or headlights on)
◆ Engine and other Check Lamps:
1. When the key is turned to "START", lamps
(1 engine oil pressure) should come on. If
trouble codes occur at any location with
engine running,
corresponding to that location comes on.
IMPORTANT :
 Relying on the engine warning lights is
never enough. Never fail to conduct daily
checks carefully by referring to Pre
Operation Check " in "PERIODIC SERVICE"
section.
5. Turn the key to the "START" position and
release when the engine starts.
IMPORTANT:
 Because of safety devices, the engine will
not start except when the gear shift lever is
placed in the "NEUTRAL" position and the
brake is depressed.
1-23
the warning lamp