Wheel Bolt Torque - Hisun HS 250UTV Owner's/Operator's Manual

Introduction HS 200UTV/HS 250UTV
[1] Gear shift lever pivot (spray type grease )
■Checking engine start system
CAUTION
TO avoid personal injury

Do not allow anyone near the vehicle
while testing.

If the vehicle does not pass the test, do
not operate the vehicle.
◆Preparation before testing
Place all control levers in the "NEUTRAL"
1.
position.
2. Set the parking brake and stop the engine.
◆Test Gear shift range lever safety switch
Sit on the operator's seat.
1.
Shift the gear shift range lever to: "L", "H",
2.
or REVERSE position.
Turn the key to "START" position.
3.
4. The engine must not crank.
5. If it cranks consult your local dealer for this
service.
[1] Brake pedal
[2] Accelerator pedal
■Checking wheel bolt torque
CAUTION
To avoid personal injury

Never operate vehicle with a loose
wheel bolts.

Any time these bolts are loosened
they should be retightened to the
specified torque.

Check all bolts frequently and keep
them tight.
Check wheel bolts regularly especially when
new if they are loose tighten them as
follows:
① Torque wheel bolts to 65 to 78 N.m
1-40