Replacing Engine Oil Filter; Replacing Transmission Oil - Hisun HS294-2 Owner's/Operator's Manual

drain the oil into an oil pan.
3. After draining, reinstall the drain plug.
4. Fill with the new oil up to the upper notch
on the dipstick.
(See "LUBRICANTS, FUEL AND
COOLANT" in "MAINTENANCE" section.)
[Filter exchanged] 1.8L (1.89U.S. qts.)
Oil capacity
[Filter non-
exchanged]
① Oil Leve
② Dipstick

■ Replacing Engine Oil Filter

CAUTION
Hitch coupling device
1.6L (1.68U.S. qts.)
12-80
the mounting surface. Tighten filter by
hand an additional 1/2 turn only.
5. After the new filter has been replaced, the
engine oil normally decreases a little. Make
sure that the engine oil does not leak
through the seal and check the oil level on
the dipstick. Then replenish the engine oil
up to the prescribed level.
① Bolt; ② Cover
③ "O" seal ring;
④ Engine oil filter
IMPORANT:
⚫
To prevent serious damage to the engine,
use only a genuine filter.

■ Replacing Transmission Oil

CAUTION
To avoid personal injury:
⚫
Be sure to stop the engine before
changing oil.